ECS PF21 Extreme, Руководство пользователя, Страница: 32 / 85

3-5
Delay Prior to Thermal [16 Min]
Thermal Management [Thermal Monitor 1]
TM2 Bus Ratio [0X]
TM2 Bus VID [0.8375V]
Limit CPUID MaxVal [Disabled]
Item Help
Menu Level
Phoenix-AwardBIOS CMOS Setup Utility
CPU Feature
F5:Previous Values F6:Fail-Safe Defaults F7:Optimized Defaults
: Move Enter: Select +/-/PU/PD:Value F10:Save ESC:Exit F1: General Help
Enables you to set the delay time before the CPU enters auto thermal mode.
Delay Prior to Thermal [16 Min]
Thermal Management [Thermal Monitor 1]
This item sets CPU’s thermal control rule to protect CPU from overheat. This feature
is only available when CPU supports Thermal Monitor 2.
TM2 Bus Ratio [0 X]
This item helps you to set the frequency (bus ratio) of the throttled performance that
will be initiated when the on die sensor goes from not hot to hot. You may set the bus
ration number from 0 to 255.
TM2 Bus VID [0.8375V]
This item helps you to set the voltage of the throttled performance that will be initiated when the on
die sensor goes from not hot to hot.
Limit CPUID MaxVal [Disabled]
This item limits the CPUID maximum value. Enable this item to install WinNT. Leave this item at
the default value for other OS.
Press <Esc> to return to the Advanced BIOS Features page.
Hard Disk Boot Priority (Press Enter)
Scroll to this item and press <Enter> to view the following screen:
1. Pri.Master:
2. Pri.Slave:
3. Sec. Master:
4. Sec. Slave:
5. USBHDD0:
6. USBHDD1:
7. USBHDD2:
8. Bootable Add-in Cards Item Help
Menu Level
Phoenix-AwardBIOS CMOS Setup Utility
Hard Disk Boot Priority
Use < > or < > to
select a device, then press
<+> to move it up, or <-> to
move it down the list. Press
<ESC> to exit this menu.
: Move PU/PD+/-/:Change Priority F10:Save ESC:Exit
F5:Previous Values F6:Fail-Safe Defaults F7:Optimized Defaults
CPU L3 Cache [Enabled]
Some high-end processors support L3. If the CPU do support L3, you may set this
item to enable or disable. Leave this item at the default value for better performance.