ECRON YTSF40-22, Руководство пользователя

Страница: 43 / 46

43
EN
The FAN may be operated by the manual controls located
on the FAN (Figure 2) or by remote control (Figure 1).
The remote control features two batteries LP03 (AAA), 1.5V
each.
- Remove the door of the battery compartment on the back
of the remote control.
- Fit the batteries according to their polarity (i.e. attention
must be paid to the symbols "+" and "-").
- Fit the battery compartment door back in place.
1. Place the FAN on a stable flat surface. Plug the cord set
into a 220-240V. electrical outlet.
2. SPEED/ON: Turn the FAN on and Low speed by pressing
the ‘SPEED/ON’ button first time, and you can adjust the fan
speed to the desired level: Low, Medium, or High.
3. OFF: Turn the FAN off by pressing the ‘OFF’ button again.
4. MODE: Pressing the ’MODE’ button will set the FAN into
NORMAL, NATURAL, and SLEEP mode.
5. TIMER: The fan is equipped with a timer that allows you to
CLEANING AND STORAGE
• Unplug the fan before cleaning.
• Use only a soft cloth to gently wipe the fan clean.
• DO NOT immerse the fan in water and never allow water to
drip into the motor housing.
• For storage, clean the fan carefully as instructed and store
your fan in a cool dry place.
set it's length of operation from 0.5 hour to 7.5 hours.
6. SWING: Pressing the ‘SWING’ button will start and stop
the oscillation function.
Orientation of the ventilated air
The airflow can be directed to your request, up or down. To
make this adjustment, loosen the wheel tilt adjustment,
located on the fan body. Be sure to tighten the knob after
adjustment