ECRON YTSF40-22, Руководство пользователя

Страница: 39 / 46

39
EN
ASSEMBLE
1. Place Stand A on Stand B to form X-base.
2. Place lower pipe with pipe support on X-base with four
screws provided.
3. Loosen and remove the pipe connector from lower pipe.
Slide plastic base ornament over lower pipe onto the base.
Extend upper (inner) pipe and slide pipe connector over
upper pipe into lower pipe and tighten.
4. Attach the motor with switch housing onto the upper pipe.
Ensure the switch housing is pushed fully onto the upper pipe
and secured with the screw provided.
5. Loosen guard mounting nut from the motor housing.
6. Position rear guard firmly to motor housing and then
fasten by turning guard mounting nut clockwise tightly.
7. Remove and discard the PVC sleeve on the motor shaft.
8. Push the blade along motor shaft and fasten it firmly with
spinner by turning counter clockwise.
9. Hang the front guard to rear guard with the position fixer
provided at the rim of guard and then fix together with
screws and clips provided.
The FAN may be operated by the manual controls located
on the FAN (Figure 2) or by remote control (Figure 1).
The remote control features two batteries LP03 (AAA), 1.5V
each.
- Remove the door of the battery compartment on the back
of the remote control.
- Fit the batteries according to their polarity (i.e. attention
must be paid to the symbols "+" and "-").
- Fit the battery compartment door back in place.
1. Place the FAN on a stable flat surface. Plug the cord set
into a 220-240V. electrical outlet.
2. SPEED/ON: Turn the FAN on and Low speed by pressing
the ‘SPEED/ON’ button first time, and you can adjust the fan
speed to the desired level: Low, Medium, or High.
3. OFF: Turn the FAN off by pressing the ‘OFF’ button again.
4. MODE: Pressing the ’MODE’ button will set the FAN into
NORMAL, NATURAL, and SLEEP mode.
5. TIMER: The fan is equipped with a timer that allows you to
set it's length of operation from 0.5 hour to 7.5 hours.
6. SWING: Pressing the ‘SWING’ button will start and stop
the oscillation function.
Orientation of the ventilated air
The airflow can be directed to your request, up or down. To
make this adjustment, loosen the wheel tilt adjustment,
located on the fan body. Be sure to tighten the knob after
adjustment