2
Indoor unit installation;
Outdoor unit installation;
Install the refrigerant pipe;
Connect the drain pipe ;
Electric wiring work;
Installation of the decoration panel;
Test operation.
If the refrigerant leaks during installation, ventilate the area
immediately.
Toxic gas may be produced if the refrigerant comes into
contact with fire.
K
eep the interconnection cable away from the copper tub
ing
.
After completing the installation work, check that the refrigerant
does not leak.
Toxic gas may be produced if the refrigerant leaks into the
room and comes into contact with a source of fire, such as a
heater, stove or cooker.
Ground the air conditioner.
Do not connect the ground wire to gas or water pipes, lightning
rod or a telephone ground wire.
Inappropriate grounding may
result in electric shock.
Be sure to install
a ground fault circuit
breaker.
Failure to
do so
may result in electric shock.
Connect outdoor unit wires, then connect indoor unit wires.
Do not c
onnect the air conditioner with the power supply until
the wiring and piping is done.
I
nstall drain piping in order to ensure proper drainage and
insulate piping to prevent condensation.
Improper drain piping may result in water leakage and property
damage.
I
ndoor and outdoor units, power supply wiring and connecting
wires should be at least 1 meter away from televisions or radios
to prevent interference or noise.
Depending on the radio waves, a distance of 1 meter may not
be sufficient enough to eliminate the noise.
The appliance is not intended for use by young children or
infirm persons without supervision.
Don't install the air conditioner in the following circumstance:
The appliance shall be installed in accordance with national
wiring regulations
and local authority having jurisdiction
.
Do not operate your air conditioner in a wet room such as a
bathroom or laundry room.
An all-pole disconnection device which has at least 3mm / 0.1in
clearances in all poles , and have a leakage current that may
exceed 10mA, the residual current device (RCD having a rated
residual operating current not exceeding 30mA, and
disconnection must be incorporated in the fixed wiring in
accordance with the wiring rules.
CAUTION
There is
petroleum
existing
,
There is salty air surrounding (near the coast
),
There is caustic gas (the sulfide, for example existing in
the air (near a hot spring)
,
The
power supply is unstable
,
In buses or cabinets
,
In kitchen where it is full of oil gas
,
There is strong electromagnetic wave existing.
There are inflammable materials or gas.
There is acid or alkaline liquid evaporating.
Other special conditions.
To install properly, please read this "installation manual" .
The air conditioner must be installed by qualified person
nel
.
When installing the indoor unit or its tubing, please follow
this manual as strictly as possible.
If the air conditioner is installed on a metal part of the
building, it must be electrically insulated according to the
relevant standards to electrical appliances.
When all the installation work is finished, please turn on the
power only after a thorough check.
This product may change without notice.
INSTALLATION INFORMATION
INSTALLATION ORDER
