Set Up
Recommendations 1-2-3
Charge Your EcoEdge
Before you power on your
EcoEdge, connect the USB
Micro port to the USB cable
and a 5V power source to
fully charge your EcoEdge for
best performance.
NOTE:
Before using your
EcoEdge for the first time,
charge the unit until all battery
level indicators are green,
indicating a full charge.
Approximately 3 hours of
charging is required from a low to
a full charge.
Power source options include
the USB connection to your
computer or a power outlet
using a 5V USB to AC power
adapter. It is recommended
to always use the USB cable
included with your EcoEdge.
1
RF WARNING STATEMENT:
1) This device may not cause interference, and
2) This device must accept any interference,
including interference that may cause
PRODUCT USE AND PROTECTION:
Read and follow all instructions.
Use only as intended.
The ECOXGEAR Bluetooth speaker is intended
to be used indoors or outdoors and in land
or water environments. The speaker has been
tested to IP67 waterproofing standards, which
means the speaker can be submerged in up
to 3 feet of water for 30 minutes without any
damage. However, the speaker is
NOT
intended
for constant underwater use.
Always make sure the cap(s) / covers(s) are
clean, free from sand or debris, and correctly
fitted. The speaker will only meet IP67 ratings if
all rubber seals, gasket(s), and cover(s) / cap(s)
are in place. If you notice a muffling of audio
after submersion, gently shake the unit to clear
excess water. If your speaker is exposed to salt
receiver is connected, consult the dealer or an
experienced radio/TV technician for help.
The device has been evaluated to meet
general RF exposure requirement. The
device can be used in portable exposure
condition without restriction.
FCC ID:2AAUI-GDIEXEDGE301
IC STATEMENT:
This device complies with Industry Canada
licence-exempt RSS standard(s). Operation is
subject to the following two conditions:
undesired operation of the device.
IC:11210A-GDIEXEDGE30
