Ecosy+ Hampton 5 Large, Руководство пользователя

Страница: 11 / 15

Page 11 of 15
When the stove is new the paint is very tacky where the stove is curing. The door locks very tight and
when opened can pull away the fire rope from its chamber. If the instructions are followed above this
should not happen. However, if it does the rope will need to be stuck back in place with “heat resistant
fire rope glue” After a few burns the paint will be cured and this should no longer happen.
Refuelling
Every stove will work slightly differently depending on the chimney, or flue system it is attached to. It can
take time to get use to the stove and how best to run and control it in each situation.
At nominal power output, your stove will require refuelling approximately every hour.
It is important to follow these instructions in order to achieve clean burning and to maximise the
efficiency of the stove
Do not leave the fire unattended until flames are well established on the newly charged logs
Always refuel onto hot embers.
If the fire has died out at the point of refuelling, use kindling to re-establish the fire and follow the
“Ignition” procedure above.
It is important that the stove is not overloaded with fuel.
Reduced burn rates can be achieved by reducing the openings of the Secondary and Tertiary air
vents.
Refuelling on to a low fire bed – If there is insufficient burning material in the firebed to light a new
fuel charge, excessive smoke emission can occur.
Refuelling must be carried out onto a sufficient quantity of glowing embers and ash that the new fuel
charge will ignite in a reasonable period. If there are too few embers in the fire bed, add suitable
kindling to prevent excessive smoke.
Fuel overloading - The maximum amount of fuel specified in this manual should not be exceeded,
overloading can cause excess smoke.
Operation with door left open – Operation with the door open can cause excess smoke. The appliance
must not be operated with the door left open except as directed in the instructions.