EcoReco M3, Руководство пользователя

Страница: 11 / 25

DASHBOARD AND ACCELERATOR
9
Accelerator lever:
The scooter is equipped with Safe-Start
protection to limit unintended jerking;
you must first “roll” the scooter manually
for initial speed before the accelerator
lever becomes activated. Place your
finger(s) over the accelerator lever and
push in as desired to accelerate.
Power button:
Press for about 1 second to power on
and about 3 seconds to power off.
Mode selection button:
Press as needed to switch between the following functions:
Battery status:
Five black bars mean the battery is fully charged. The fewer the black bars, the less the
remaining battery capacity.
Speedometer:
Graphic bars display the current speed in mph.
TRIP: Distance traveled since last resetting the display.
(To reset, hold down the MODE button while in “Trip” mode until the display flashes
twice.)
ODO: Odometer (ie, total distance traveled).
ODO SET: Numerical speedometer (ie, current velocity of the scooter)
SET: Charging cycle counter.
1.
2.
3.
4.
5.
For quality assurance, an EcoReco scooter must go through several test rides and
charging cycles. Therefore, the ODO and SET modes might display miles ridden and
charging cycles upon receipt.
If the SET icon does not appear, it means the counter is under the metric (kilometer)
system. Simply press the MODE button for 5 seconds twice to switch to the imperial
(mile) system, and the SET icon will appear.
RO
TA
RE
LE
CC
A
/
DR
AO
B
HS
AD
Note:
(a)
(b)
(c)
(d)
Accelerator lever
Power button
Mode selection button
Speedometer
Battery status