Page 4
OMNI by EconoHeat
I M P O R TA N T
Notice to the owner and installer
To enjoy the long-term beneits of burning your used oil in an OMNI Waste Oil Burning appliance,
it is necessary to become familiar with the correct installation operation and maintenance
of your new furnace. Before installing or operating this appliance, make sure you read and
understand this manual.
IMPROPER INSTALLATION, ALTERATIONS, OR LACK OF MAINTENANCE WILL VOID THE
WARRANTY.
The most critical sections of this manual are in order of importance as follows:
• Basic Operation Knowledge
• Oil Suction Line Installation
• Correct Draft Over Fire
• General Maintenance Requirements
Identical to any gas or oil furnace, without adequate draft over the ire, the combustion
gases cannot escape the furnaces. The lame will lengthen resulting in an overheated
combustion chamber.
Even if the heater is installed correctly and adequate draft achieved,
a lue passage blockage will affect the draft. Burning used oil is similar to burning wood. A
ine gray ash accumulates in the chamber and lue passage. This accumulation of ash will
eventually affect the draft. It is important to remove this ash before the draft is affected.
These topics are discussed in detail on the pages listed above. Please familiarize yourself with
these sections of your manual. Spending a few minutes to review this material will assure that
you receive the return on investment that you expect from your OMNI heater.
