Page 30
ecom-
J2KN
pro
TECH
11.6. Mean value measurement
By mean value measurement function measurements can be taken
in an adjustable time frame and mean values can be calculated.
Should the several measurement values or the mean value result be
stored a storage place has to be selected as described in chapter 7.
If the function
“Store”
is activated, based on this storage place all
measurements will be written consecutively on the next storage
places. If the function
“Store”
is not activated, the mean value result
can be stored on MMC with
<Print> / „Memory -> M
.
After run through fresh air calibration
the menu point
“Mean value”
can be
chosen.
Before
the
mean
value
measurement can be started the
settings for
“Meas.time”
,
“Scanning”
,
“Printer”
and
“Storage”
should be
checked and if necessary be changed.
The meanings are:
-Meas. time
= Time frame in which the
mean values will be calculated
-Scanning
=
time
between
the
measurements taken for mean value
calculation
-Printer
= logging of measurements
taken for mean value calculation
-Store
= all measurements for mean
value calculations will be stored
“Measurement time”
and
“Scanning”
can be adjusted as follows:
-select menu point and confirm with
<OK>
-with the numeric keys set the desired time:
0.01 = 1 sec. = minimum value
59.59 = 59 min and 59 sec. = maximum value
-confirm with
<OK>
Gas analysis
Mean value
Pressure
Soot..Oil trace
Data processing
Adjustments
Control
Diagnostics
Start measurement
Meas. time
Scanning
Printer
Store
Mean value
Quit with:
Содержание J2KNpro Tech
Страница 1: ...Operating Instructions ...