38
4. Using PTT, select the frequency number from the 9 different numbers 0-8.
Each time you press it, the frequency number changes accompanied by a
signal tone.
Operation
Channel number Signal tone
Press and hold
PTT for 2 seconds
0
1 second tone
Press PTT one time
1
.
Press PTT two times
2
..
Press PTT three times
3
...
Press PTT four times
4
....
Press PTT five times
5
.....
Press PTT six times
6
-.
Press PTT seven times
7
-..
Press PTT eight times
8
-...
Please observe:
Select channel number "0" when not selecting any channel. To do so, press
PTT for about 2 seconds until a 1-second long signal tone sounds.
If PTT is pressed more often than 8 times, a signal tone sounds and no value
is selected.
5. The respective signal tone of the selected number sounds after 2 seconds.
6. Press the monitor key to end this setting. The red LED flashes two times.
7. Press the monitor key again to confirm the signal tone of the desired number.
8. Program another channel as described in steps 3 through 7 above.
Example: Changing a channel storage space (11) to channel number 8
1. Select channel storage space 11 in the set mode.
2. Press PTT 8 times to select 8 as the channel number. Each time you
press it, a signal tone will sound.
3. After 2 seconds, one long and three short signal tones sound, to confirm
your selection of channel number 8.
4. Press the monitor key to complete the setting. The red LED display flashes
Содержание Ex-PMR 1000
Страница 1: ...Ex PMR 1000 Operating Instructions...
Страница 24: ...49 15 EC Type Examination Certificate...
Страница 26: ...51...