10
Hard disk
Use only the hard disk supplied for the digital recorder or hard-disk models recommended for this purpose.
Fitting the hard disk supplied
1.
Switch off the digital recorder and open the hard disk slot.
2.
Turn the handle to face upwards and pull the HDD frame carefully out of the slot. (Keys and fitting
screws are contained in the HDD frame.)
3.
Push the plastic lock of the HDD frame cover down and push the upper cover of the HDD frame
back.
4.
Change the hard disk jumper so that the hard disk works as MASTER.
(For WD disks, remove the jumper.)
5.
Connect the hard disk supplied to the HDD frame using a 4-pole power cable and a flat-tape
data cable.
6.
Fix the hard disk with two screws on the left and two screws on the right of the HDD frame and
then close the frame with the upper cover.
7.
Insert the HDD frame back into the slot, push it until engages, and turn the handle to face down.
Now lock the hard disk with the key.
