Ecolab GEOCENTER, Инструкция по установке и эксплуатации

Страница: 20 / 22

2. Check fuse on the board - replace if necessary (1 amp
slow-blow fuse).
3. Check that time delay potentiometer is fully counter
clockwise.
1. Check Rinse Dispenser - Service as necessary.
2. Remove discharge tube from injection fitting. Activate final
rinse.
a. If product dispensed. Replace check valve.
b. If no product dispensed. Replace peristaltic tubing.
3. Check injection fitting for obstruction, clean and replace
as needed.
4. Check squeeze tube for wear and replace if in doubt.
1. Check final rinse - if running continuously, correct the
problem.
1. Check tubing connections for air leaks.
2. Check for high rinse pressure - optimum is 15-20 psig (1-
1.4 BAR) and cannot be over 35 psig (2.4 BAR).
3. Check squeeze tube for wear and cracks etc.
1. Lubricate, use only silicon grease lubricate.
2. Replace roller assembly.
1. Remove squeeze tube - if fuse does not blow, replace roller
assembly.
2. If fuse blows, disconnect pump motor leads from terminals
3 and 4 activate Rinse Speed Control P.C Board.
a. If fuse blows, replace Speed Rinse Control P.C.
Board.
b. If fuse does not blow, replace pump motor.
9.8 rinse Injector does not activate
(continued).
9.10 rinse Injector runs continuously
9.11 rinse Injector will not prime.
9.12 excessive squeeze tube wear.
9.13 fuse on Speed rinse p.c. board is
blowing repeatedly.
9.9 rinse Injector runs, no rinse additive be-
ing injected.