ECOFOREST BREMEN, Руководство по установке и обслуживанию

Страница: 39 / 192

38
To channel the Venecia stove, the convection air mouths (

) on the stove should be replaced by channelling
enabled ones (

) (see parts diagram). To undertake this operation, the lining (

) must be removed. In order to do
this, the fireplace door must be replaced by dismounting it from the hinges in two easy stages. Lift up the door until
it has gone beyond the pin of the upper hinge, detach it and then lower it until the door is free of the lower pin.
Beware! Be careful when handling the door to avoid any damage to the ceramic glass. Once this stage is reached the
lining removal differs from model to model. I.e. for the Venecia Glass you only have to remove the four bolts that the
stove has on each side of the fireplace, which can be accessed once the door is off and which allow the lining to be
removed. For the Venecia Bambú, you only have to remove 2 bolts that are to be found on the sides at the bottom
of the door front, and then lift the lining until it is detached from the stove. With the lining removed from the stove,
the top of the stove can now be extracted (

), which is anchored by 4 bolts on the ends of the hoppers. Remove the
rectangular shaped mouths (

) that are attached by 4 bolts, 2 on each side, and replace them with the tubular
mouths (

) for convection air channelling. With the mouths fitted, replace the top, the lining and the door of the
fireplace.
Drawing 11
The convection air in the Suez stove has a combination of 6 modes for operation. Depending on the position
of the exchanger knobs, the stove will expel convection air through the front (knob pushed in, fixed in the last
position), through the back mouths for air channelling (knob pulled out fixed in the first position) or dividing the flow
between both outlets (knob in the middle position).

Exchanger knob.
Drawing 12
KEYBOARD CONECTION, POWER WIRING AND ROOM THERMOSTAT.
The first thing to do is locate the keyboard in the fireplace inside a box, with the remote control, room
thermostat and power wiring, and cleaning brush.
For the Suez and Turbo Aire stoves, the bolts that fix the stove stand (

) must be adjusted as shown in figure
13 . Connect the keyboard ribbon connection lead (

), which is held in place on the back by an adhesive tape, and
connect it to the back of the keyboard (

), there is only one position that connects.
For the Oslo and Bremen, there is a gap for the keyboard on the left side of the lining; fit the keyboard and
connect the ribbon cable (

).
For the Suez Insert and the chassis of the Oslo , a space must be left in the decoration of 42 x 126 mm for the
keyboard to be fitted and the ribbon cable connected (

). This is due to these models having been designed both in
their dimensions and shape to be fitted into a tailor-made decoration.
The Venecia stove is supplied with the keyboard fitted on the left side (looking at the front of the stove),
which can be moved to the opposite side if needed.
The atmospheric probe and the power lead are connected at the back of the Suez , Turbo Aire and Venecia
stoves, as shown in figure 13 (Suez). Connection is the same for the other stoves in this manual, located on the left