ECOALLIANCE DYNAHEAT ECO-155LE, Руководство пользователя, Страница: 8 / 18

8
Installation details
This Eco Alliance DynaHeat
™
hot water heat pump system must be installed by a licenced person in
consideration of the following standards and regulations:
• AS/NZS3500 National plumbing and drainage code hot water supply systems – acceptable
solutions.
•
HB 263-2004 Heated water systems plumbing industry commission.
• AS/NZS3000 Electrical installations (known as the Australian/New Zealand wiring rules).
• Notice to Victorian customers from the Victorian Plumbing Industry Commission, the Victorian
Building Act 1993 requires that this DynaHeat™ heat pump water heater system must be installed
by a licenced person. Only a licenced person will provide a compliance certificate showing that the
work complies with all the relevant standards. Only a licenced person will have insurance
protecting their workmanship.
• The unit has been specifically designed for domestic hot water heating and may not be suitable for
any other purpose.
•
The unit is designed to operate when connected to the town water supply with an operating
pressure rated at 500kPa. To ensure the mains pressure does not exceed this, a pressure-limiting
device that complies with AS1357 can be connected to the town water supply line, but is not
essential.
•
This system delivers hot water exceeding 55◦ C. Reference should be made to AS/NZS3500 and/or
local regulations relating to the need for temperature tempering devices.
• The unit must be stored and transported in an upright position. Failure to do so may render the unit
faulty. Such failure is not covered under any warranty agreements. Failure to comply with the
above conditions will void the warranty.
Figure 2: Typical Installation Layout