Eco Range 15/21, Инструкция по использованию, установке и обслуживанию

Страница: 7 / 35

The warranty will become invalid if you strip and rebuild the cooker yourself.
5.1 Site Considerations
1. Sufficient space for appliance, so that access for service and maintenance purposes
can be easily attained.
2. Provision of a satisfactory flue/chimney/cowl.
3. A sold non-combustible hearth capable of supporting the appliance.
4. Adjacent to the cooker then should be no combustible walls or surfaces.
5. The cooker must stand against an outside wall so that there is a supply of unrestricted
air to the burner.
6. If the cooker is to be placed within an inglenook, allow a minimum of 1.5 meters
height clearance for comfortable operation.
7. Units and other work tops should be given enough space, allow 25mm for kitchen
units and 10mm for worktops, 3mm should be given for granite and composite stone.
8. The cooker must not be built in, especially the top plate and front plate which must
be removed for maintenance.
6.0 Balanced Flue
A balanced flue allows the cooker to be placed against an outside wall, with either rear or
top outlet concentric flue.
Maximum length of rear flue:
500mm
Maximum length of top outlet flue: 300mm vertical
500mm horizontal
The surrounding area must be taken into consideration, as strong winds may affect flue
performance.
Balanced flue units are supplied with the following components:
1 no. Outer flue pipe 5” (air intake)
1 no. Inner flue pipe 3” (exhaust outlet)
1 no. Flue terminal
1 no. Heatproof silicon
4 no. Stainless steel self-trapping screws
1 no. Oven vent pipe with tee
Instructions for installation:
1. A suitable position for the range must be taken into consideration before attempting
to install or move the appliance. See section 5.1 for site considerations.
2. Mark the positions for the flue and oven vent, it is important to confirm all
measurements by physically measuring the appliance.
3. Push oven vent through hole and manoeuvre cooker into position. After the cooker
has been moved to the correct position, tighten the compression fitting so that there is
a 3/5º drop from appliance to outside termination.
4. Cut the pipes to the correct length.