Important Safety Instructions
Carefully read and follow all safety
instructions in this manual and on pump.
SAVE THESE INSTRUCTIONS – This manual
contains important instructions that should be
followed during installation, operation, and main-
tenance of the product. Save this manual for
future reference.
Safety Labels
This is the safety alert symbol. When you
see this symbol on your pump or in this manual,
look for one of the following signal words and be
alert to the potential for personal injury!
Indicates a hazard which, if
not avoided, will result in death or serious injury.
Indicates a hazard which,
if not avoided, could result in death or serious
injury.
Indicates a hazard which, if
not avoided, could result in minor or moderate
injury.
NOTICE
indicates practices not related to
personal injury.
Keep safety labels in good condition. Replace
missing or damaged safety labels.
Under certain conditions,
submersible pumps can
develop extremely high pressure. Install a pres-
sure relief valve capable of passing entire pump
flow at 100 PSI (690 kPa).
Do not allow pump, pressure
tank, piping or any other
system component containing water to freeze.
Freezing may damage system, leading to injury
or flooding. Allowing pump or system compo-
nents to freeze will void warranty.
Can shock, burn or cause
death. To avoid dangerous
or fatal electric shock
hazard, use pump only in a water well.
Do not install this pump in a pond, river or
other open body of water that could be used
for swimming or recreation. Do not swim,
wade or play in a body of water in which a
submersible pump has been installed.
Install ground and wire
pump according to local
and Canadian Electrical Code or National
Electrical Code requirements that apply.
Disconnect electrical
power supply before
installing or servicing pump.
Make sure line voltage
matches pump voltage
and frequency.
Install pump according to all plumbing, pump
and well code requirements.
Test well water for purity before using well.
Call your local health department for testing
procedure.
During installation, keep well covered to pre-
vent leaves and foreign material from falling
into the well. Foreign objects in well can con-
taminate water and cause serious mechani-
cal damage to pump.
Pipe joint compound can cause cracking in
plastics. Use only teflon tape when sealing
joints in plastic pipe or connecting pipe to
thermoplastic pumps.
For parts or assistance, call ECO-FLO Customer Service at 1-877 326-3561
HAZARDOUS PRESSURE
HAZARDOUS VOLTAGE
GENERAL SAFETY
4
