Make sure that all the parts are clean without any oil, dust, especially on the
handle and control parts, to avoid the tool drop easily during the operation.
1)
1) First press the
for 3 s to turn on the power, the tool will self-test for 1 s,
the data showing the last record, the tool is ready to work.
Inspect the battery to see if it is charged or run out.
2)
Select the right dies for the intended application,
Don’t operate the tool without dies.
the crimping head has to be opened by pushing the Latch, insert two dies top and
bottom, the steel ball located center of the die will match the hole of the latch and die
holder when both die halves are in place. Then the connecting material shall be
positioned in the crimping head correctly, in order to start the crimping procedure,
3)
A crimping process is initiated by switching the trigger. It is defined by the closing
motion of the dies. The connection material is positioned in the stationary half of the
crimping dies and the moving part is approaching the compression point.
4)
A crimping cycle is terminated when the dies contacted each other and when the
maximum crimping force is reached. After the crimping cycle is completed, the piston
retracts automatically. Afterwards a new crimping cycle can be initiated or the
crimping process can be terminated by opening the latch and removing the connector
material out of the head.
The crimping process can be interrupted at any moment by releasing the trigger
button.
Do not put your fingers into the head of the tool during operating. Your fingers could
be pinched very severely.
understood by the operator that common sense and caution are factors which cannot
be built into this product, but must be supplied by the operator
.
UNDERSTAND YOUR TOOL
902-484 is a tool for crimping Cu lugs with cables from 16-400 mm
2
. It is powered by
Li-ion, actuated by motor and controlled by MCU. With a high pressure hydraulic system,
LED light, LCD , error warning alarm, pressure showing..etc function, it is a perfect tool to
be used in electrical construction site.
1. Specification
Max. crimping force:
6 Ton
Crimping range:
CU AWG 6 to 600MCM
Stroke:
.67 inch
Crimp/Charge
320 times(Cu 300MCM)
Time/crimp:
3-6s( depend on the size of cable)
Hydraulic oil:
Shell Tellus T15#
Capacity:
115ml
Ambient temperature
-10-40
℃
Voltage:
DC
18V,3Ah
Charging voltage:
AC 100V
～
240V ;50
～
60Hz
Charging time:
Approx.2 hours
Accessories:
Crimping die:
6,4,.2,.1/0.2/0.3/0.4/0. 300,350,500,600MCM
Battery:
2 pcs
Charger:
1 pc
Sealing ring of cylinder:
1 set
Sealing ring of safety valve.
1 set
