16
8.2 Transport
In order to avoid injury or damage to the unit it must be handled properly. In addition to
following the instructions below, general health and safety good practice and specific
accident prevention guidelines should be observed.
For correct handling and storage comply with the following symbols:
Protect against moisture
Careful: glass
Up
Centre of gravity
Do not compress the side walls of the unit or any attached parts by pulling obliquely on
ropes or chains.
Only remove handling safeguards once all installation work has been completed.
When handling in a loading area make sure the unit cannot topple over or slip.
Damage caused during transportation must always be reported to the manufacturer.
8.3 Storage
If possible the unit should be stored in a closed room until final installation.
If the unit is stored in the open it must be covered over with tarpaulins and open
underneath, to allow condensation to drain off.
If the unit has been packed for transportation by sea the packaging must not be
damaged or opened during transit and storage.
For correct storage comply with all storage and handling symbols:
Protect against moisture
Careful: glass
Up
