USER MANUAL
– PROCAM HD 3D
Page
11
of
15
INMANUUIN136 Rev.2019.04.01 / ENG
After five seconds of selecting a level for this function, it will be stored in memory. This means
that, in case you turn the splitter off, the Brightness/Gain level set in the equipment when you turn
it on again will be the last one you selected before turning the splitter off.
When the splitter is recording the set level in memory, the White Balance LED indicator (central
position) will blink.
5.3 WHITE BALANCE FUNCTION
The White Balance function allows the equipment to perform an internal calibration to
compensate the differences in color temperatures of different light sources, ensuring reliable color
reproduction. Since this function adjusts the camera parameters for a particular light source, the
White Balance procedure must be performed each time the light source to be used with the
equipment is changed.
To get the White Balance, focus on a completely white and illuminated image with light intensity
at maximum power and press the White Balance button for approximately 3 seconds.
This White Balance remains stored in memory even when the camera is turned off. During the
White Balance setting, the White Balance indicator flashes to indicate that the White Balance is
being performed, then when the White Balance button is not pressed the LED indicator remains
off.
Only if the White Balance is set correctly, reliable color reproduction is guaranteed.
Perform a new White Balance if the light source is changed.
Always perform the White Balance with the light source that will be used to carry out the
procedure afterwards.
6. MAINTENANCE
6.1 CLEANING
Before cleaning the 3D HD Splitter, disconnect the power cable from the electric power
supply.
Do not sterilize nor immerse in liquid the device or any of its accessories or parts.
CLEANING OF EXTERNAL SURFACES
To clean the outer surfaces of the device only use a soft cloth dampened in mild detergent or
soap. Only use adequate cleaning products prepared for electrical equipment following the
product’s instructions.
We recommend cleaning the external surfaces once every 15 days.
Never use flammable products, especially alcohol, when the unit is hot.
While cleaning, be careful not to let water or humidity get into the equipment.
Do not use any abrasive agent.
