9
10.
Auto Standby: keep pressed (for 2 secs.) to activate/deactivate the auto
standby function. If this is activated, after 2`30” with no audio in the inputs and
if the remote controlled is not used, the unit will switch to standby mode.
11.
Reset: keep pressed (for 2 secs.) to reset the system to its default values: BT
priority ON, volume = 30 bass; treble = 0.
12.
Flat: keep pressed (for 2 secs.) to reset the system to its default equalizer
values: bass = 0; treble = 0.
Remote port (only applies to the eMOTUS5BT model)
REMOTE
port: the RJ-45 REMOTE type connector makes it possible to connect from
a type WPmVOL wall control panel (control 0-10 VDC) for adjusting the general
output volume. The connection is made by a standard CAT5 cable between the
WPmVOL wall panel and the REMOTE connector on the MASTER unit.
As there is an eMOTUS5PB kit along with a type WPm control and other types of
control (rotating control on the rear panel, remote control or control via remote
port), at all times, the latest adjustments made using one or another method will
prevail. For instance, if the volume is adjusted using a WPmVOL wall panel
connected to the REMOTE port, and then said parameters are altered using the
control on the rear panel, the latest adjustment will prevail. In this case, when the
position of the wall panel is altered again, the eMOTUS5PB kit will retake the values
that this indicates, and so on.
N.B.
the green LED light will keep on whenever the unit is on. It will blink on and off
when there is activity in the remote controls (remote control or 0-10VDC port).
