14
Fig 3
Fit and tighten the two Head Locking Knobs - see Figure 4 bellow. (Note The locking knob fixing holes
should be on the same side with the extension pole Locking Knob fixing holes)
Fig 4
Installing the guide bar and saw chain
to the chainsaw/lopper attachment:
1.
Loosen the SDS bar cover knob and remove the bar cover .See Fig 7
.
Fig 7
2.Position the chain around the sprocket and then around the guide bar. (Note: If the chain is not properly
fitted over on the sprocket, the chain saw lopper will not work and could cause serious injury). Mount the
guide bar to the power head by the bar cover with SDS button .(Note: the lopper head incorporates an SDS
chain tightening system. The inner knob is used to fasten the cover. The outer knob is used to tension the
chain .) See Fig 8 as below.
