ECKELMANN CI 4000 Series, Инструкция по эксплуатации

Страница: 123 / 147

Firmware V6.6.9 29.07.2020 123/147
•
•
•
Remote control using terminal mode
The terminal mode screen is opened using the Remote Control button. In the terminal mode, all parameters of
the receiver module including the associated wireless sensors can be configured. For more information, see
chapter
Remote control of E*LDS components (terminal mode) . The assigned CAN bus address, diverse
statuses and operating statuses are also displayed.
5 Menu 4-5 - General Information
The screen for general information of the store is called using this button.
The screen contains the following parameters:
General information Read only!
Operating time of the system centre Years / days /hours
Operating time of the display Years / days /hours
System up time Years / days / hours / minutes / seconds
"Information for open source software" button
QR code with specification of the hyperlink where further information about
the use of Open Source software components (
Licence Reports ) is
described in detail for the present product:
Link to E°EDP of Eckelmann AG: https://edp.eckelmann.de/edp/lds/
_V0brLLadsi
6 Menu 4-6 - Users
The screen for user management of the system centre is called up using this button. All users
created in the system are displayed there. The following users are available: Admin, Master and Service; for
further details see chapter
Login to the system centre (unlocking) .
The screen contains the following parameters:
Change password Description
Tips and requirements Minimum length 8 characters
The password must not contain the user name (e.g. “Admin” or “admin”)
The password must contain at least three of the following four elements
- Numbers (0-9)
- Lowercase letters (a-z)
- Uppercase letters (A-Z)
- Special characters limited to (.@-)
Attention! Security Note! For security reasons, all passwords set at the factory should be changed
immediately after installation and commissioning!
