ECKELMANN CI 3000, Инструкция по эксплуатации

Страница: 74 / 134

Operation of CI 3000
68 Version 2.09 09. April 2014
Exiting menus and screens
Press the ESC key to exit the menu or screen you are in at any time. This returns you to the next higher menu.
All menus and screens are closed automatically if no key is pressed for 10 minutes. The display then jumps to
the Main Menu or to the Alarm menu if any fault report is currently active.
Special functions
A number of special functions can be invoked by combinations of keys:
‐ Triggering of test alarms:
Prio X1: by simultaneously pressing the buttons MODE and 1
Prio X2: by simultaneously pressing the buttons MODE and 2
Prio X3: by simultaneously pressing the buttons MODE and 3
…
Prio X9: by simultaneously pressing the buttons
MODE and 9
‐ Simultaneously press the MODE and ESC and 6 keys
to delete the operating archives and reorganize archive management (is entered in message log).
‐ Simultaneously press the MODE and ESC and 8 keys to perform restart.
Frequent restarting while the Store Computer is powering up (about 2 min.) can result in errors in
archive management.
7.2.1 Deactivate entry block
The release of the lock is only to be carried out by service personnel!
With activated setpoint interlock (restricted setpoint changes) a password is necessary.
For detailed instructions see menu 9-3.
Before any values can be entered, the entry block must be deactivated as follows:
‐ In the Main Menu choose item 9 Parameter Setting.
‐ Then choose item 3 Block.
‐ Press ENTER (
↵
) to set the check mark (
√
). When the check mark is set, entry block is deactivated, al­
lowing settings to be entered.
‐ Press ESC to exit the screen.
Unblocking from the main menu unblocks entry for all components of the CAN bus system. If you
have moved to the operator interface of a bus station but have omitted to deactivate entry block, si­
multaneously press the MODE and decimal ( . ) keys to unblock entry for the particular controller.
Entry block is reactivated on exiting the operator interface for the controller.
Blocking is activated automatically if no key is pressed for 10 minutes and when the Operator Termi­
nal is switched on.