ECKELMANN AL 300 W, Инструкция по эксплуатации

Страница: 26 / 61

Installation and Startup of AL 300
21
Version 3-1 05. Dezember 2019
4. Then carefully lift off the front panel and carefully set it down in upright position (see picture)!
Do not bend the ribbon cable!
5. Pull battery (a) up out of its holder (see arrow in picture) dispose of it in regulation manner.
Never dispose of this product with other household waste. Please inform yourself of the local regula­
tions for the separate disposal of electrical and electronic products. The correct disposal of your old
equipment will protect people and the environment from possible negative effects.
You will find further information in the chapter ”Decommissioning and Disposal”.
Do not touch the new battery with metal pliers, as it might be short-circuited and destroyed:
- wipe the new battery with a clean, dry cloth,
- do
not touch the contact faces on the edges of the new battery.
6. Pick up the new battery with a cloth and press it in its holder.
7. Re-assemble in the reverse order. Before doing so, make sure the green two-pin connector is properly
connected (arrow in picture).
8. Re-install the AL 300 in the control panel and re-connect all connectors.
9. Re-connect the AL 300 to the power supply.
10. After applying the power supply, the AL 300 Operator Terminal with unchanged configuration of the
system centre / store computer is detected again automatically via the CAN bus. Date, time and automatic
summer time / winter time changeover are set automatically using the central time synchronisation via the
system centre / of the store computer if these are present.Otherwise this synchronisation takes place
using the operator terminal that has the lowest CAN bus address.
Messages or alarms generated on restarting the AL 300 must be checked and/or cancelled on the
System Centre / Store Computer or other AL 300 Operator Terminals!