EchoStar DISH 500+, Руководство по установке

Страница: 7 / 28

5
Set skew. To access the skew bolts, loosen the elevation bolts and elevation rod nuts. Loosen
the skew bolts. Set the skew by rotating the elevation and skew bracket to align the mark with the
required angle on the skew scale that you entered on page 4 (see Figure 2). Tighten the skew bolts
securely to keep the reflector from rotating. See Table 1 on page 9 for the required torque values.
Note: After the skew is set, do not try to fine-tune the skew angle when aiming the reflector.
Figure 2. Skew Plate
Set elevation. Set the elevation by loosening the elevation bolts and elevation rod nuts. Tilt the
elevation and skew bracket to align the edge of the azimuth plate with the required angle on the
elevation scale. Tighten both nuts on the elevation rod to hold the elevation, but do not tighten the
elevation bolts at this time (see Figure 3).
Figure 3. Setting the Rough Elevation Angle
7.
6.