Page 5
ELEDR(H) Installation Guide
Linking the First Switch
Use this method to link the first switch. Use the learn button to link additional
devices.
1.
If the controller already has a sensor linked, press the TEACH button on
the linked sensor and proceed to step 2 within 60 seconds.
2. Click the wireless switch paddle ON three times, OFF three times and
ON three times sequentially within 5 seconds. The relay will toggle and
the red POWER LED will begin a repeating blinking pattern to indicate
the linked switch, see the section on LED blink codes.
LEARN button
The LEARN button is used to link switches or sensors to the controller.
1.
Press the button marked LEARN for a half second. In link mode the
LEARN LED will stay ON and the POWER LED will toggle every two
seconds.
2. When linking a wall switch, press the switch paddle ON three times.
If linking a sensor, press the sensor’s TEACH or LINK button, refer to
the sensor’s documentation. The POWER LED will remain lit for four
seconds while it links the new device. It will resume toggling allowing
you to link another device up to a total of twenty devices.
3.
To exit link mode, press and release the LEARN button on the controller.
i
Note:
Linking a switch or sensor that is already linked to a
channel, will remove or unlink it from the channel.
i
Note:
Link mode will time out after no activity in thirty
seconds.
Power Load Controller
Power
LED
Clear
Button
Learn
Button
Learn
LED
Antenna (orange)
Do not cut or cap
Black - Line,
120-277VAC OR
240-347VAC
@ 50/60 Hz
500 mW max
White - Neutral
Red - Load, Switched Hot
Max. Switching Load:
(ELEDR) 20A@120-277VAC
Electronic Ballast or LED Driver
(ELEDRH) 20A@240-277VAC
Electronic Ballast or LED Driver
(ELEDRH)16A@347VAC
Electronic Ballast or LED Driver
Max. Impulse Voltage: 4000V
Internal Relay: Type 1.C
Motor load rating:1.5 HP @ 120VAC and 3.0 HP @ 277VAC.
Load
Neutral to others
Red - To other loads
Max load
(ELEDR) 20A@120-277VAC
Electronic Ballast or LED Driver
(ELEDRH) 20A@240-277VAC
Electronic Ballast or LED Driver
(ELEDRH)16A@347VAC
Electronic
Ballast or LED Driver
Wiring Diagram
