Echo SRM-3611T, Руководство оператора

Страница: 12 / 164

10
Before you start
Loop handle version
Loop handle assembly
Assemble loop handle (A) and bracket (C) to drive shaft assem-
bly.
Position handle in comfortable operating position and tighten
Bolts (B).
U-handle version
U-handle assembly
1. Install handle assembling bracket (upper) (A) in handle as-
sembling bracket (lower) (B) and fix handle by tightening
handle assembling bolt (C) lightly.
2. Adjust inclination of handle to adequate position (easy to op-
erate) and tighten firmly handle assembling bolt.

To adjust the fixture bolt (D) proceed (As needed)
(1) Tighten the bolts until snug.
(2) Loosen the bolts 1
1
/
2
turn.
E: Arrow
F: To engine
3. To eliminate loosening of throttle wire (I), fix it to shaft tube
(H) (2 places) and to right hand U-handle (1 place) with wire
fixing clips (G).
K: Nuts
E: Arrow F: To engine
CAUTION
 Install the handle to the engine side from the arrow
mark.
CAUTION
 Install the handle to the engine side from the arrow
mark.
CAUTION

After assembly, adjust the play of wire end (J) on carbu-
rettor (L) side to 1 mm - 2 mm.