Echo SRM-335ES, Руководство оператора

Страница: 26 / 132

24
Maintenance and care
Angle transmission
1. Remove the plug (A) and drain screw (B) from the angle
transmission (C).
2. Add grease into the transmission until old grease is pushed
out. If necessary, use a low pressure pump.
3. Reinstall the drain screw and plug.
Checking the blade
Œ
Use only blade designated for this model by the manufacturer.
Œ
When a crack is noticed on the blade, do not use it but replace
with a new one.
Œ
Ensure that the blade is correctly fitted in accordance with the
instructions.
Œ
When the cutting blade becomes dull due to wear reverse it for
further use.
Œ
When chip or bend occurs on the blade, vibration will increase.
Replace with new one.
Œ
When filing the blade file 3 cutting edges evenly using a flat file
as shown in the illustration. Otherwise, the balance will be lost
and vibration will increase.
Installing nylon line cutter (option)
Œ
There are two types of shields: namely the one used exclu-
sively for nylon line cutting head and the other one used exclu-
sively for metal blade. When using nylon line cutting head, use
the shield for nylon line cutting head.
1. Fully loosen the bolt (A) on the right side of the bracket (B)
to slide the shield. The bolt itself cannot be removed from the
bracket.
2. Pushing the button (C), slide the shield (D) to the left and re-
move it.
3. Put shield of other type (E) into groove and slide it to the right
until it stops. Be sure to tighten the bolt.
Troubleshooting table
NOTE
Use good quality lithium multi grease.
IMPORTANT

For spare parts and consumables, please use only genuine parts and designated products and components.
Using parts from other manufacturers or non-designated components may result in a malfunction.