ASSEMBLY
SRM-3020U
18
X7502350202
© 12/2019 ECHO Inc.
Throttle Linkage and
Ignition Leads
1.
Close choke and remove air
filter cover and air filter.
2.
Place throttle wire assembly (A)
into adjustment fixture (B) and
install wire end into large
carburetor throttle swivel hole
(C).
3.
Turn throttle wire retaining clip
clockwise to lock into place.
4.
Check throttle for freedom of
movement. Verify that wide
open throttle and low idle extremes are adjusted properly.
Note: The throttle linkage must be adjusted by moving the
adjustment nut. Consult with your dealer for correct
adjustment procedure.
5.
Connect ignition stop leads (D)
from throttle cable assembly to
ignition leads (E) on engine.
6.
Install air filter and air filter
cover.
Blade Installation
Blades must be selected for type of cutting being performed. See “Blade
Selection.”
You must install the U-handle and all blade conversion parts
shown in the following instructions before operating this unit
with a metal blade, otherwise serious injury may result.
A
B
C
D
E
A
B
C
E
D
