![background image](http://html1.mh-extra.com/html/echo/shred-n-vac-es-255/shred-n-vac-es-255_operators-manual_531662019.webp)
ES-255
OPERATION
X7531180307
19
© 07/2013 ECHO Inc.
4.
Purge Bulb
Pump purge bulb (D) until fuel is visible and flows freely in the
clear fuel tank return line.
Recoil starter: Use short pulls - only 1/2 ~ 2/3 of rope for
starting. Do not allow the rope to snap back in. Always hold the
unit firmly.
5.
Recoil Starter
Place the unit on a flat, clear area. Firmly grasp throttle grip
with left hand and rapidly pull recoil starter handle/rope (E)
until engine fires, or maximum 5 pulls.
6.
Choke
Move choke lever (C) to Run (
) position, and if necessary,
restart engine.
Note: If engine does not start with choke in “Run” position after
5 pulls, repeat instructions 3 - 6.
7.
Throttle Position Lever
After engine starts, move throttle position lever to idle position, and allow engine to warm up for 3 minutes
before use.
8.
Throttle Trigger
After engine warms up, depress throttle trigger or move throttle position lever to increase engine RPM to
operating speed.
Starting Warm Engine
The starting procedure is the same as Cold Start except DO
NOT close the choke.
1.
Stop Switch
Move stop switch (A) away from the STOP position.
2.
Throttle Position Lever
Move throttle position lever (B) midway between idle and full
throttle positions.
C
D
E
A
BB
A