P
OWER
P
RUNER
TM
O
PERATOR
'
S
M
ANUAL
21
STARTING
COLD
ENGINE
WARNING DANGER
The cutting attachment should not move at idle. If cutting attach-
ment moves, readjust carburetor according to "Carburetor Adjust-
ment" instructions in this manual or see your ECHO Dealer,
otherwise serious personal injury may result.
1.
Stop Switch - Start/Run.
Move stop switch button (A) forward away from the STOP
position.
2.
Choke - Cold Start.
Move choke (B) to “Cold Start” Position.
3.
Primer Bulb -Purge.
Pump primer bulb (C) 10 times. Fuel will be visible and flow freely in
the clear fuel tank return line.
WARNING DANGER
Inspect starting area for hazards such as rocks, glass, debris etc.
which could be contacted by the cutting attachment when starting.
Keep helpers and bystanders at least 15 M (50 ft.) from starting
area, otherwise serious personal injury may result.
4.
Lay the pruner on a flat clear area. Firmly grasp right hand grip and
throttle trigger lockout with left hand and fully depress throttle
trigger to wide open position. Rapidly pull recoil starter handle/rope
(D) until engine fires (or maximum five [5] pulls).
5.
After engine fires or five (5) pulls, move choke lever to “Run”
position. Hold throttle trigger and throttle lockout fully depressed
and pull recoil starter handle/rope (D) until engine starts and runs.
Release throttle trigger and allow unit to warm up at idle for several
minutes.
NOTE
If engine does not start with choke in “Run” position after 5 pulls,
repeat instructions.
6.
After engine warm up, gradually depress throttle trigger to increase
engine RPM to operating speed.
A
B
C
D
Содержание Power Pruner PPT-2100 1
Страница 2: ......
Страница 11: ...POWER PRUNERTM OPERATOR S MANUAL 11 1 12 11 10 2 3 9 14 15 16 17 18 19 20 21 13 8 7 6 5 4 22 23 24 ...
Страница 34: ...34 NOTES ...
Страница 35: ...POWER PRUNERTM OPERATOR S MANUAL 35 NOTES ...