10
A
SSEMBLY
ATTACHMENT
SHAFT
ASSEMBLY
Tools Required: None
Parts Required: PAS Attachment Assembly
1. Set Power Head/Shaft Assembly on a level surface.
2. Pull locator pin (A) out, and turn counter-clockwise 1/4 turn to lock-
out position.
3. Carefully fit attachment drive shaft assembly into coupler (B) to
decal assembly line (C), making sure that the inner lower drive shaft
engages into the square upper drive shaft socket.
NOTE
Lower bearing housing and head assembly must be in line with the
engine.
4. Rotate locator pin (A) 1/4 turn clockwise to engage lower shaft
hole. Insure locator pin is fully engaged by twisting lower drive
shaft. Locator pin should snap flush in coupler. Full engagement will
prevent further shaft rotation.
5. Secure lower shaft assembly to coupler by tightening clamping
knob (D).
D
A
A
B
D
C
B
FRONT
HANDLE
ADJUSTMENT
/
BARRIER
BAR
ASSEMBLY
Tools Required: Screwdriver.
Parts Required: Barrier Bar
Handle Adjustment
1. Stand in a comfortable operating position with attachment as-
sembled, and position front handle for comfortable operation.
Tighten handle screws.
Barrier Bar Assembly
NOTE
The barrier bar may be used with all attachments unless instructed
otherwise in the attachment Operator's Manual.
1. Unscrew bottom bracket of handle, and replace with Barrier Bar as
shown. Adjust handle and secure as described above.
