![background image](http://html1.mh-extra.com/html/echo/cs-3000-type-1e/cs-3000-type-1e_instruction-manual_3948939009.webp)
9
STARTING WARM ENGINE
•
Ensure that there is fuel and chain oil in the tanks. (If fuel
tank was emptied during previous operation, refill tank and
push purge bulb 10 times.)
•
Turn switch (A) to “RUN” position.
•
Pull starter handle.
•
Choke may be used if necessary, but be sure to push it
back on first firing sound.
NOTE
If engine does not start after 5 pulls, use cold start
procedure.
RUNNING
•
After engine starts, allow it to return to idle.
•
Move chain brake lever fully rearward to release chain
brake.
•
Squeeze throttle trigger with throttle control lockout
gradually to increase engine speed.
•
Saw chain starts moving when the engine reaches
approximately 4200 rpm.
•
Ensure proper acceleration and lubrication of chain and
bar.
•
Do not run the engine at high speed unnecessarily.
•
Be sure that saw chain stops moving when throttle trigger
is released.
STOPPING
•
Release throttle trigger and turn switch (A) to STOP
position.
NOTE
If engine does not stop, pull choke out fully to stop
engine.
Check and repair stop switch before starting the engine
again.
CS-3450
CS-3000
CS-3400
A
A
CS-3450
CS-3000
CS-3400
A
A
Содержание CS-3000 TYPE 1E
Страница 22: ...22 NOTES...
Страница 23: ...23 NOTES...