S
HAFT
H
EDGE
C
LIPPER
A
TTACHMENT
O
PERATOR
'
S
M
ANUAL
9
A
SSEMBLY
POWER
HEAD
SHAFT/LOWER
SHAFT
ASSEMBLY
Tools Required:
None
Parts Required:
Power Head Shaft, Lower Attachment/Shaft
Assembly
1. Set Power Head/Attachment Shaft Assembly on a level surface.
2. Pull locator pin (A) and rotate counter clockwise 1/4 turn to lock
out position.
3. Carefully fit lower drive shaft assembly into coupler (B) to decal
assembly line (C), making sure that the inner lower flex cable
engages into the upper drive shaft coupler mount.
NOTE
Earlier model Power Heads may have shorter couplings. Short
couplings fit flush to decal point (E). New couplings are 4-3/4 in.
long, and fit flush to line (C).
NOTE
Lower bearing housing and tine assembly must be in line with
the engine.
4. Rotate locator pin (A) 1/4 turn clockwise to engage lower shaft
hole (D). Insure locator pin is fully engaged by gently twisting
lower drive shaft.
5. Locator pin (A) should snap flush in coupler. Full engagement
will prevent further shaft rotation.
6. Secure lower shaft assembly to coupler by tightening clamping
knob (D).
S
PECIFICATIONS
A
B
D
E
C
D
C
A
MODEL ---------------------------------------------------- SHAFT HEDGE CLIPPER ATTACHMENT
Length ------------------------------------------------------- 1264 mm
Width -------------------------------------------------------- 76 mm
Weight ------------------------------------------------------ 2.3 kg
Gear Case Ratio -------------------------------------------- 5.62 : 1
Cutter -------------------------------------------------------- Double Reciprocating Blade - Double Edge
Cutter Length ----------------------------------------------- 475 mm
Cutter Pitch ------------------------------------------------- 35 mm
Maximum Diameter Cut ------------------------------------ 13 mm
