Echo 99944200595, Руководство оператора

Страница: 13 / 20

PAS A
rticulAting
H
edge
c
liPPer
A
ttAcHment
O
PerAtOr
'
S
m
AnuAl
13
6mm (.25 in.) Radius
A A
45
º
IMPORTANT
Flat edge of washer (D) must be against drive shaft.
C
A D
1. Carefully remove locating screw (A) and loosen clamping screw
(B). Remove the flex drive shaft assembly from the gear housing.
2. Pull the drive shaft (C) from the drive shaft assembly, and wipe
clean. Re-coat with a thin coating [1/2 oz. (15 ml)] of grease.
3. Slide the flex shaft back into the drive shaft assembly, being careful
not to get dirt on the flex shaft.
4. Align the locating screw hole in gear case with the locating hole
in drive shaft assembly, install and tighten locating screw (A), and
tighten clamping screw (B).
B
1. Move stop switch to stop position.
2. Disconnect spark plug wire.
3. Slide blades to allow file clearance using slots (B) on bottom of
blade. Do not pry against cutting edges.
4. File each edge carefully. Follow the original shape of the blade.
IMPORTANT
If a power grinder is used DO NOT allow blade to over heat.
5. Lubricate blades (see “Lubrication instructions”).
IMPORTANT
Blades should only be removed and reinstalled by an Authorized
ECHO Servicing Dealer, otherwise premature wear or internal
damage may occur.
sharpenIng blades
Level 2.
WARNING
Hedge Clipper blades are very sharp. Touching them may lead to
severe personal injury. Avoid touching blades whenever possible,
and always wear gloves to protect hands.