8
Parts Required:
PAS or SRM-SB Power Head w/Shaft & Coupling.
1. Set Power Head/Shaft Assembly on a level surface.
2. Pull locator pin (A) out, and turn counter-clockwise 1/4 turn to
lock-out position.
3. Remove vinyl cap from attachment drive shaft.
4. Remove cardboard spacer, if necessary.
5. Carefully fit attachment drive shaft assembly into coupler (B) to
decal assembly line (C), making sure that the inner lower drive
shaft engages into the square upper drive shaft socket.
NOTE
Earlier model Power Heads may have shorter couplings. Short
couplings fit flush to decal point (E). New couplings are 4-3/4 in.
long, and fit flush to line (C).
NOTE
Lower bearing housing and head assembly must be in line with
the engine.
6. Rotate locator pin (A) 1/4 turn clockwise to engage lower shaft
hole. Insure locator pin is fully engaged by twisting lower drive
shaft. Locator pin should snap flush in coupler. Full engagement
will prevent further shaft rotation.
7. Secure lower shaft assembly to coupler by tightening clamping
knob (D).
D
C
A
a
ssembly
A
B
D
E
C
fronT
loop
handle
removal
Parts Required:
None
NOTE
Front loop handles/loop handles with barrier bars are not recom-
mended for use with this attachment.
1. Remove front handle assembly, barrier bar (if installed), and
mounting hardware from PAS or SRM-SB power head.
2. Retain parts for future use.
WARNING
Do not perform maintenance or assembly procedures with engine running.
power
head
shafT
/
lower
shafT
assembly
Содержание 99944200595
Страница 18: ...18 notes ...
Страница 19: ...19 notes ...