EN
36
EN
37
CLEANING AND MAINTENANCE
Before cleaning or any other handling of the induction hotplate pull out the plug of the power cord
from the power socket and allow the hotplate to cool down!
While the hotplate is cooling down keep it out of reach of children!
After it has cooled down clean the glass ceramic surface and the control panel with a cloth and for dirty
areas use a slightly damp cloth dipped in dish washing detergent.
Do not use abrasive sponges or cleaning powders. Neither the induction hotplate nor the power cord
may be submerged in water!
Keep the surface of the hotplate clean at all times to prevent the accumulation of dirty materials in the
area of the fans and its subsequent malfunction. To wipe dust from the air inflow and outflow areas
use cotton buds or a toothbrush with a small amount of cleaning agent, which is not aggressive and
carefully remove oil stains.
Carefully wipe away remains of cleaning agents from the hotplate using a damp cloth, otherwise then
may burn to the hotplate when it is turned on.
TROUBLESHOOTING
If while using the induction hotplate you discover a problem, please read the following information
before contacting a service centre:
Problem
Possible cause
Solution
The induction hotplate is not
working (the On light is not
on).
The power cord is not
connected to the power
socket.
Check the electricity supply (by
connecting a cord to the power
socket).
The pot is too small, the
diameter of the bottom is
smaller than 12 cm.
Use an appropriate pan.
The pot is not located in the
centre of the induction zone.
Move the pan to the centre of the
heating zone.
Inappropriate type of pot/
pan.
Purchase a pan that is appropriate
for induction cooking.
The induction hotplate is not
functioning.
Disconnect the induction hotplate
from the electrical power supply
and contact a service centre.
The induction hotplate is
working but not sufficiently
(the On light is on).
Insufficient cooling by air.
Check that the required distance
from surrounding walls is adhered
to and whether the air inflow and
outflow openings are not covered.