English
English
7
Connection to the power supply
Power supply requirements
Check on the label of the appliance that the rated voltage corresponds to the mains to which it will be
connected. The mains circuit should be dedicated to the dishwasher only and must be protected by a 10/13/16
A fuse, time fuse or a protective switch.
Electrical wiring
Check that the supply voltage and frequency correspond to the values on the appliance label. Only connect
the power cord to a power outlet that is properly grounded. If the mains socket to which the appliance is to be
connected does not match the power cord plug, replace the outlet. There is a risk of overheating and ignition
when using the adapter.
•
Make sure the appliance is properly grounded before using it.
Water supply and drain hose
The water distribution system must be suitable for the installation of the dishwasher. We also recommend
that you install a filter at the water inlet to prevent damage to the appliance due to contamination by dirt
(sand, clay, rust, etc.) that may be in the plumbing or domestic water mains. This will prevent the dishes from
yellowing and dirt from accumulating in the appliance.
Cold water connection
Connect the cold water supply hose to the 3/4-inch diameter screw
fitting and make sure it is securely attached. If the supply pipe is new or
has not been used for a long time, let the water flow for a while until it is
completely clean. This will prevent possible blockage of the water supply
and damage to the device.
Safety supply hose
The hose has double walls. The hose system ensures that the water flow is
shut off in the event of a hose break or water ingress into the space between the double hose walls.
Connecting the safety water supply hose
1. Pull the safety supply hose completely out of its storage compartment at the back of the dishwasher.
2. Attach the cap to the water supply with 3/4 inch thread and tighten fittings.
3. Open the water supply tap fully before using the dishwasher.
Connecting the drain hose
Connect the waste hose to the waste pipe with a minimum diameter of 4 cm or insert it into the sink and
ensure that it does not bend or break. The hose outlet must be located at a height of less than 1000 mm. The
free end of the hose must not be immersed in water to prevent water flowing back.
