ECG EDB 6007 QXA++, Инструкция по эксплуатации

Страница: 52 / 72

GB
52 52
52
2. Turn on the dishwasher using the button “Power”.
3. Hold the button “Delay” and then press for 5 seconds the button “Program”. A beep signal sounds and the
display fl ashes H. (the default setting is H4).
4. Press the “Delay” button to change the setting. The value of the dose increases by 1 level with each
pressing of the “Delay” button. After reaching H7, it jumps with next pressing of the “Delay” button to H0
(dispensing is off ).
5. Press the button “Program”. The setting is saved in the memory of the appliance.
Water hardness table
Water hardness
mmol/l Set value
°Clark Hardness
0-8 soft 0-1.1 H0
9-10 soft 1.2-1.4 H1
11-12 medium 1.5-1.8 H2
13–15 medium 1.9-2.1 H3
16-20 medium 2.2-2.9 H4
21-26 hard 3.0-3.7 H5
27-38 hard 3.8-5.4 H6
39-62 hard 5.5-8.9 H7
Note:
• The water hardness can vary in each area.
• If hard water would be used, deposits would form on the dishes and cutlery.
• The appliance is equipped with a special water softener using salt dispenser designed to remove calcium
and other minerals from the water.
ADDITION OF SALT TO WATER SOFTENER
The salt dispenser is located under the bottom basket. Fill it according to the following description:
•
Use only salt designed for dishwashers! Other types of salts, which are not intended for dishwashers, for
example kitchen salt would damage the water softener. In case of damage caused by use of improper salt
the manufacturer does not keep warranty and is not responsible for any damage.
• Replenish salt just before starting one of the complete washing programs. You will prevent corrosion due
to left over salt crystals or overfl owed solution on the bottom of the dishwasher.
1 2
A. Remove the bottom basket and then unscrew the lid of the salt dispenser
1
.
B. If you fi ll the dispenser for the fi rst time, fi ll to 2/3 of the volume with water (about 500 ml)
2
.