ECD DO82, Инструкция пользователя

Страница: 36 / 52

HYDRA-DS NO
3
-N Page 35
6.0 TROUBLESHOOTING
Problem Possible Cause Remedy
NO
3
-N Reading Low Dirty Coated electrode Clean sensor:
Soak in 2% HCU for 5 minutes to remove algae or
rinse with weak detergent 10-15 seconds solution
to remove oils.
Soak in tap water for 30 minutes after either
cleaning method. Increase frequency of the air
blast cleaner
Old Expired NO3 ISE Perform two point calibration, the slope > 40
mV/decade if not replace NO3 Sensor
Inaccurate Potassium compensation Verify Chloride ISE reading with single point
calibration.
Adjust Cl coef (see section 4.0.5)
NO
3
-N Reading High Ammonium Sensor has drifted Perform a single point calibration
Low or No Chloride ion
Compensation Verify Cl comp is ON
Verify Chloride ISE reading with single point
calibration
Adjust Cl coef (see section 4.0.5)
Interfering Ions Present in Sample Influx of interfering ions causing error, wait for ions
to clear the process, Iodide, Bromide, HS-,
Chlorate, Chlorite, Carbonate, Bicarbonate, Nitrite
No Response to
Changing Nitrate Bad Electrode Visual inspect membrane for cuts, if torn replace
electrode
Remove the electrode examine for breakage, torn
o-rings, corrosion or moisture, if any of these
issues are present:
Switch out old electrode with a new electrode,
check response, if good recalibrate the HYDRA-DS
Bad Sensor Switch out old electrode with a new electrode,
check response, if still bad examine electrode tube
for signs of moisture.
If present remove sensor from installation and
allow the sensor to dry out. Retest with a new
electrode, if it still fails return it to the factory for
refurbishment.