Eccotemp SMARTHOME, Инструкция по установке, использованию и уходу

Страница: 24 / 39

Support: Support.Eccotemp.com Shop Online: eu.Eccotemp.com Store Locator: eu.Eccotemp.com/locator
24
EN
G
LI
SH
PLEASE NOTE: SH12 IS FOR INDOOR PERMANENT INSTALLATIONS ONLY. THIS MANUAL AND ALL ECCOTEMP CONTENT IS SUBJECT TO CHANGE WITHOUT
NOTICE. PLEASE VISIT SUPPORT.ECCOTEMP.COM FOR THE MOST UP TO DATE WARRANTY AND MANUAL.
Indoor water heaters must be installed
with CAT III vent pipe in accordance with
vent supplier/ manufacturer in accordance
with local code. Owner must refer to vent
manufacturer’s instructions and
A. BACK INSTALLATION
1. Insert the vent pipe through the
installation holes in the wall with the terminal
sticking out.
2. Connect the elbow to the vent pipe and
water heater, moving straight backwards
of the water heater. Screw the nuts tight
(pay attention to the direction of the elbow).
B. SIDE INSTALLATION:
1. Aim the holes in the water heater onto
the nuts tightly.
2. Put the vent pipe through the holes in the
wall, and connect the elbow with the water
heater and vent pipe.
C. VERTICAL INSTALLATION
Please refer to local installation professional
or venting manufacturer:
The installation hole in the wall needs to
thimble, making sure the water heater is tight
Make sure the location of the water heater allows for easy access
and operation.
In case of dry wall or concrete wall use dry wall anchors or lag bolts.
The water heater requires 220 V/ 50Hz. Have a receptacle with
ground terminal near the water heater. The length of the power
supply cord is 5 ft.(1.5m).
bottom holes.
wood thread screws into the bottom holes.
CAUTION: Reinforcement of the wall is required in case the wall is not
strong enough to hold the water heater.
Back Installation
Side Installation
3.9”
9.9cm
9.9 cm
4.
8”
12
.1
cm
5.5”
3.9”
2.9”
4.
8”
12
.1
cm
3.9”
5.5
”
13.9cm
Mounting
(9.9cm)
(7.3cm)
(9.9cm)
(1cm)
(14.3cm)
(14.3 cm)
(5
9.
6c
m
)
(5cm)
Installation
Holes
IN
ST
A
LL
AT
IO
N
P
Sealant