Page 4 of 8
Figure 5
22 PIN MALE
Figure 6
Stick the base
support onto the
vehicle
Installation instruction of using pedestal base
1. Select suitable position on vehicle and fix the base support. (Figure 5)
2. Fix the monitor to the base support and adjust the view angle.
3. Put on the sun-visor and connect the monitor with the AV and power supply conversion cable (Figure 6)
Remote Control Opera
ƟŽŶ
1. MUTE
To mute/unmute the volume
2. POWER
Power off/on button
3. MENU
Menu control button
4. UP
Menu selection up
5. DN
Menu selection and display mode (single, dual, triple, quad-view, PIP image) selection
6. VOL-
to decrease the volume and switch between values of each sub-menu
7. VOL+
To increase volume and switch between values of each sub-menu
8. MODE
Menu selection and display mode (single, dual, triple, quad-view, PIP image) selection
9. SEL.
Jump key selector. Fast jump to the display mode specified by SYSTEM SETUP
10. P/N
PAL/NTSC TV system selector
11. LANG
Language selection
12. REST
To restore factory settings
13. AV
To go to/leave DVD channel
1. MUTE
To mute/unmute the volume
2. POWER
Power off/on button
3. MENU
Menu control button
4. UP
Menu selection up
5. DN
Menu selection and display mode (single, dual, triple, quad-view, PIP image) selection
6. VOL-
to decrease the volume and switch between values of each sub-menu
7. VOL+
To increase volume and switch between values of each sub-menu
8. MODE
Menu selection and display mode (single, dual, triple, quad-view, PIP image) selection
9. SEL.
Jump key selector. Fast jump to the display mode specified by SYSTEM SETUP
10. P/N
PAL/NTSC TV system selector
11. LANG
Language selection
12. REST
To restore factory settings
13. AV
To go to/leave DVD channel
WARNING!
1. Please align the remote control with the remote signal receiver window to operate.
2. Never disassemble the remote control or allow it to drop or get wet.
!