ECA • 10 Mountain View Drive • Shelton, CT 06484 • Phone: 1-800-521-3175 • Fax: 203-924-6687
www.electri-cable.com
9065-0002 RevF
2
Innovat ive Power + Dat a Solut ions
Step 5.
INNER PAN MOUNTING - Place the INNER PAN ASSY. to the underside of the table and secure with twelve
(12) #10 X ½ screws provided, use pilot holes to ensure proper alignment.
NOTE:
USE CAUTION WHEN
POSITIONING THE INTERCEPT 2 ON THE TABLE, ENSURE THAT THE GRAIN OF THE CUTOUT PIECE
MATCHES THE TABLE.
Step 6.
OUTER PAN MOUNTING - Position the OUTER PAN ASSY. below the mounted INNER PAN ASSY. Connect
the power feed (Twist-Lock), and motor feed wires (RED and BLACK) from the OUTER PAN ASSY to the
MAIN HOUSING Twist-Lock and motor. Be sure to feed the wire through the cutout in the OUTER PAN.
Attach the OUTER PAN ASSY to the underside of table with six (6) #10 X ½ screws provided. Use pilot holes
to ensure proper alignment.
Step 7.
Plug the ROCKER SWITCH ASSY onto the cable utilizing the 4-pin connector, plug in the unit and test for
proper operation. By pressing the “Raise” side of the ROCKER SWITCH the INTERCEPT 2 should elevate
and lock at top. By pressing the “Lower” side of the ROCKER
SWITCH the INTERCEPT 2 should return to the
original, retracted, position.
#10 x ½ Screws
Qty 12
(If other than
included screws are
used, be careful not
to pierce finished
side)
Inner Pan
Assembly
Underside of
Table
#10 x ½ Screws
Qty 6
(If other than
included screws
are used, be
careful not to
pierce finished
side)
Outer Pan
Assembly
Inner Pan
Assembly
Underside of
Table
Rocker
Switch
Assembly
Twist-Lock
Connector
4-Pin
Connector
