22
EBTRON • 1663 Hwy. 701 S., Loris SC 29569 • Toll Free: 800.2EBTRON (232.8766) • Fax: 843.756.1838 • Internet: EBTRON.com
IG_GTM
1
1
6
‐
B_
R1
A
G
OLD
S
ERIES
GTM116-B T
RANSMITTER
a measurable difference!
EBTRON
6A
6B
Enter code and confirm code (NOTE: if LOCK SEC= HIGH, DO NOT lose code!)
Clears all disabled trouble settings
1: NO PROBES
(example shown)
Displays unit serial number.
Displays main PCB serial number.
For sensors =1 to 9, A to G (number of sensors dependant on sensor type).
For sensors =1 to 9, A to G (number of sensors dependant on sensor type).
For sensors =1 to 9, A to G (number of sensors dependant on sensor type).
Enable/disable security lock.
Resets network settings to factory default.
O
O
FROM PART
5 'A'
Displays probe serial numbers followed by a T if connected and functioning properly, and
then followed by an F if not connected or not functioning properly.
SERIAL NUMBERS
C1 ######
C2 ######
1: NO PROBES
(example shown)
FROM PART
5 'B'
SENS VOLTS
1=H##.## T##.##
1=##.#F
RESET ADJ
BRD #####
SENS VELOCITY
1=#####FPM
SENS TEMP
C3 ######
C4 ######
DIAGNOSTICS
UNIT #######
TRBL CODES
*LOCK=OFF
SECURITY
*LOCK SEC=LOW
DSBL TRBL CODE?
ARE YOU SURE?
DSBL TRBL=NO
DSBL TRBL=YES
ARE YOU SURE?
RESET TRBL=YES
RESET TRBL=NO
Reset Flow/Pressure adjustments to GAIN = 1, OFF = 0, FLOW/PRESS ADJ = OFF
RESET NET=YES
LOCK SEC=MED
RESET ADJ=NO
RESET ALL=NO
Sets security level to MED. In this mode, a user defined code is specified. In the event of loss
of code, contact EBTRON for a unique code for this transmitter to unlock and reset code.
RESET SENS=NO
RESET ADJ=YES
LOCK=ON
ENTR CODE:0
CONF CODE:0
TRBL HISTORY
RESET
RESET ALL
ARE YOU SURE?
RESET NET=NO
RESET NET
RESET ALL=YES
RESET SENS
ARE YOU SURE?
RESET SENS=YES
ARE YOU SURE?
LOCK SET=HIGH
SET LOCK?
LOCK=OFF
SET LOCK SEC?
LOCK SEC=LOW
Sets security level to LOW. In this mode, there is no prompt for a lock code.
The last 4 digits of the board serial are used to unlock.
Sets security level to HIGH. In this mode, a user defined code is specified. In the event of loss
of code, transmitter must be returned to EBTRON for unlock / reset.
Reset sensor data, transmitter resets after completion
Reset ALL changes back to factory defaults. Transmitter resets after completion.
PROBE TYPE
TYPE= B
Type 'B' for Bleed sensors.
GTC, GTM models only
Displays active trouble codes and their descriptions. Contact EBTRON customer service for
recommended service information.
Set DSBL TRBL= YES to ignore currently displayed TRBL alarm. To disable all trouble codes,
see SETUP -> DISPLAY -> LCD TRBL.
Displays historical list of last 5 trouble codes encountered and their descriptions.
Note that spurious trouble codes may self-clear during normal operation, and this feature permits viewing them even after they have resolved.
RESET TRBL SET
