86
EN
EBS Ink Jet Systeme
20150330#1.0
EN
The
Flip horizontal
parameter can be useful if you need to label articles
from right to left or if you print on transparent materials and the prints
should be legible from the opposite side.
disabled
,
enabled
.
The
Flip vertical
parameter defines the mode of printing in the vertical
direction. It can be normal (mirror image:
disabled
) or turned upside down
(mirror image:
enabled
). The parameter is useful when an article to be
labeled is turned.
disabled
,
enabled
.
The
Initial distance
parameter defines the distance from the point where
the print release button is pressed to the point where printing of a print
should start. The distance is given as a number of millimeters, and it is
measured after the trigger has been pressed and before printing starts. It
enables you to adjust the print position in relation to the beginning of the
article.
The
Dot size
parameter is used in order to increase the intensity of prints
on porous materials, which absorb ink heavily, on which the characters
printed are not well visible due to their grainy structure. An increase in the
setting of that parameter results in higher intensity of prints made, owing to
a bigger size of ink drops jetted out of the printer head. Increased intensity
involves higher consumption of ink.
Intensity is physically constrained by the real speed at which the head can
print
– it means that when the intensity is too high for a given printing
speed, the printer signals an error with a sound signal (provided that an
appropriate warning is set
– see
)), and higher
intensity also limits the printing speed.
With the
Pressure
parameter you can adjust the force by which ink drops
are jetted, to the type of surface to be labeled. Lower pressure is
recommended for smooth, non-absorbing materials, and higher
– for
porous, absorbing materials.
