Ebode DVLHD22, Руководство пользователя

Страница: 7 / 28

7-6-2011 7 ebode DVLHD22
ƒ
Main Unit Back Panel
X
IR Sensor Extender Jack
Plug the IR Sensor Extender cable into the IR IN jack at the rear panel of the Receiver.
Generally, sensors with cable are placed near your HDTV set so that you can easily operate
and control your AV equipment connected to the Transmitter by pointing the remote
control to the TV instead of the AV equipment.
Y
HDMI OUT
For connecting the HDTV set via an HDMI
cable.
Z
DC IN
For connecting the power adapter of the Receiver.
C.
Remote Controller Unit Instruction
Button Function Description Operation
POWER
Press to turn the Transmitter /
Receiver on/off.
See the below Note 1 & 2. When
both of TX & RX Power LED are
red, Please press Power button
point at TX and RX separately. Press it pointing at Receiver to
enter “Standby” mode and the
Loop-through connection is on;
Press it
pointing at Transmitter to
enter “Standby” mode and the
Loop-through connection is off.
INFO.
Press this button to display related
information. Please refer next
page for the detail.
Press once to display the current
status. Press again to exit OSD.
SOURCE
Press this button to switch
audio/video sources connected
to the Transmitter Press to go to the next input
source. Users can see the current
setting on the OSD.
CHANNEL
Press this button to change
wireless channels manually if the
user experiences video noise.
Press once to display the current
"Channel" status.
Press again within 5 seconds to
switch to another channel, and
the channel number will be
displayed on the OSD.
WIDE
Press this button to enable the
“WIDE” mode to boost
transmission distance and keep
the same video performance; up
to 100 feet (1080i content only) Press to enable and disable WIDE
mode. Press again within 5
seconds to enable WIDE mode,
and the status will be displayed
on OSD.