ZIBU Z26HD
EN
39
www.eberg.eu
• Water is removed from the air and collected in the tank.
• When the tank is full, the appliance shuts down and ” Ft ”(full tank) appears on the display. The
tank cap must be extracted and emptied. Run off all water left into a basin. When all the water
has been drained, put the cap back in place.
• When the tank has been emptied, the appliance starts up again.
N.B.:
• When operating in very cold rooms, the appliance defreezes automatically, momentarily
interrupting normal operation. ” Lt ”appears on the display. During this operation, it is normal
for the noise made by the appliance to change.
• In this mode, you may have to wait for a few minutes before the appliance starts giving out
hot air.
• In this mode, the fan may operate for short periods, even though the set temperature has
already been reached.
When using the appliance in this mode, the air hose does not
need to be attached.
• Press the M button a number of times until the symbol
appears.
• Select the required fan speed by pressing the button.
• Fan speed can be selected: High, Med, Low,
Ideal to reduce room humidity (spring and autumn, damp rooms
rainy periods, etc).
In dry mode, the appliance should be prepared in the same way
as for cool mode, with the air exhaust hose attached to enable
the moisture to be discharged outside.
To set this mode correctly:
• Press the M button a number of times until the symbol
appears.
• In this mode, fan speed is selected automatically by the
appliance and can not be set manually.
FAN mode
DRY mode
