Eberg Qubo Q40NE, Инструкция по эксплуатации, Страница: 31 / 46

QUBO EN
31 www.eberg.eu
ATTENTION!
CLEANING AND MAINTENANCE
The air conditioner is designed in such a way as to automatically evaporate the condensed water to
the outside through the warm air exhaust pipe.
1. The continuous drain hose does not need to be connected during cooling operation. Make
sure the drain plug is clogged while the machine is running.
2. When operating in heating mode, remove the rubber plug “1” from the drain pipe and connect
the drain pipe to improve heating efficiency.
3. When operating in dry mode, remove the rubber plug “1” from the condensate drain pipe and
connect the drain hose.
• Disconnect the hot air exhaust hose to improve dehumidification efficiency (both warm and
cold air should remain in the room).
• When the water tank is full the display will show E4. Remove the rubber plug “2” from the
condensate drain pipe and empty the condensate tank. E4 will disappear when the tank is
empty. Restart the device to resume normal operation
Note:
Before starting any maintenance work, switch off the device and pull the plug out of the socket.
AIR FILTER
To clean the air filters, slide them in the direction of the arrow in the figure below - the upper air filter
to the left, the lower air filter to the right. Be careful not to confuse the filters when putting them
back in place. The filters should be cleaned regularly every 2 weeks.