Eberg CONVY WiFi, Руководство пользователя

Страница: 14 / 22

CONVY EN
14 www.eberg.eu
7. KEY FUNCTION INTRODUCTION
Insert the plug in a suitable power socket. After turn on the main switch (on the left side), the screen
displays the current room temperature. Turn on the panel control switch to display the current room
temperature and set temperature at the same time.
Then press the button for selecting the heat setting, you can select the 1000/1300/2300W/Anti-frost four
modes.
TIMER
Press the timer button, each time the time is increased by 1 hour, when the timer time is 24:00, press the
timer button, then the function is turned off, when the timer function is set, and after the timer is over, it
enters standby mode.
TEMPERATURE
Press “+” or “-” key to set the temperature (set temperature must be greater than the current temperature).
The room temperature can be set when the appliance is in stand-by or heating. When the room
temperature reaches the set level, the heater stops to work. The heater will begin operating again only
when temperature decreases 1 degrees with respect to the set temperature. The temperature regulation
range is 5°C-37°C.
MODE
Press “4-mode” to regulate 1000W /1300W/2300W/ANTI-FROST temperature power.
Note! The power consumption of the device may vary depending on the voltage.
FAN
Press the fan button to turn on or turn off the fan function. This fan works independently of the chosen
heating power.
ANTI-FROST MODE
In the standby mode, the room temperature is lower than 5°C, and automatically enters the high-grade
(2300W) heating mode. When the room temperature reaches 9°C, the heating is turned off to standby.
OPERATING SOUND
The appliance emits a beep upon each operation setting.
MEMORY
The appliance can hold the last temperature setting in its memory. This temperature will be shown at
each start-up.
8. CONFIGURATION OF CONNECTION WITH WI-FI WIRELESS NETWORK AND
MOBILE APPLICATION
1. In order to be able to remotely control a configured device using the mobile application, it must
remain connected to the power network, be turned on, be within the range of the Wi-Fi network
saved in its memory (with the name SSID and password set during configuration), this network must
access the internet and ports may not be blocked.
2. When first turned on using the main switch on the right side of the unit, the Wi-Fi will be turned
off. To turn on the Wi-Fi, press and hold the Wi-Fi button for 3 seconds. The Wi-Fi indicator will flash
quickly to indicate the unit is in AP connection mode.
3. Before initiating the connection, make sure the unit is in standby mode (Power switch ON, but
unit turned off), with the WiFi Light Indicator flashing once per second. Also ensure your phone is
connected to the WiFi network.
4. The operation of the device can only be controlled by one mobile application at a time. If you want
to change the phone which the device is operated to another one, please uninstall the device in
the application and then configure the connection with the new phone as described in the manual.
5. To turn the Wi-Fi off, the appliance can be turned off using the main switch on the left side or press