BLER
EN
12
www.eberg.eu
IV. OPERATING INSTRUCTIONS
DO NOT REMOVE THE WATER TANK WHILE THE APPLIANCE IS CONNECTED TO POWER SOURCE.
ON/OFF button
After connecting the plug to the socket, the device will be in the standby mode. Power button indicator
is lighted. After pressing the button, the device will start operating in default mode (medium speed).
Press the button again to return to the standby mode.
FAN SPEED
When device is working, press the button to set the fan speed. It is possible to select one of three levels.
The speed is changing as follows: MEDIUM -> HIGH -> LOW -> MEDIUM.
III. BEFORE FIRST USE
The remote control needs 1x CR2025 3V lithum battery. Follow the instructions of the usage and utilization
provided by the producer.
To replace or install battery, open the battery compartment by sliding the cover down. Insert the battery
in the compartment in correct position, then close the battery compartment.
•
After unpacking the device, check its conditions. Do not use the device in poor technical condition.
Report any damages found.
•
Select the suitable installation location. Comply with local safety regulations.
•
To refill the water, unlock and slide the tank out of the back part of the device. Use cold, clean,
previously boiled water. Make sure that the water level is between the marked „MIN” and „MAX” lines.
Place the water tank back in the device and lock it using the the rotary.
•
To increase the cooling effect, insert the frozen ice boxes in the tank before filling it with water.
•
Connect the plug to a suitable wall socket with the parameters specified on the rating plate of the
device.
Warning!
Keep batteries out of reach of children.
Remote control
PULL
Insulating film
Battery carriage
Release Tab
Pic.4
Pic.5
Open
Push
